If and when 271
Safety First Operating Instructions Practical Tips Technical Specifications
Changing the main headlight bulb
The procedure for changing the bulb is the same on both
sides.
– Switch off the ignition and the lights.
– Raise the bonnet.
– Pull up on the rubber cover ⇒ fig. 206 to remove it.
– Remove the connector ⇒ fig. 207 from the bulb.
– Press the spring ⇒ fig. 207 inwards and to the right.
– Remove the bulb. pulling it from the connection terminal and
fitting fit the replacement so that it sits correctly in the cut-out on
the reflector. To ensure correct lighting, the filament must be
vertical. When changing the bulb, you can check the position of
the bulb through the headlight glass.
– Installation is in reverse order, ensuring that the rubber cover is
well fitted to the housing.
– Check whether the new bulb is working.
– Have the headlight settings checked as soon as possible.
Fig. 206 Main beam
headlights
Fig. 207 Main beam
headlights
A
1
2
ExeoST_EN.book Seite 271 Freitag, 3. September 2010 11:41 11
To Next Page
