Seaward APOLLO 600+ - Page 3

QUICK START GUIDE
SEAWARD PG 3
IMPORTANT SAFETY INSTRUCTIONS
• If there are any signs of interior damage to the instrument or accessories (e.g.
loose parts in the housing), permanently remove the instrument/accessories
from operation and secure them against inadvertent use.
• Instruments and accessories from Seaward Electronic Ltd. are designed to work
optimally with the Seaward Electronic Ltd. products expressly intended for this
purpose. Unless otherwise expressly confirmed in writing by Seaward Electronic
Ltd., they are not intended or suitable for use with other products.
• Route cables in an orderly fashion, e.g. the mains power cable and accessories
cable. Loose, disorderly cables result in unnecessary danger of tripping and
falling.
Measurements/Tests
• The integrated voltage measuring function must only be used as follows:
• European Union:
The integrated voltage measuring function and mains check of the
test/measuring instrument may not be used to test systems or system
components for the absence of voltage.
Testing for the absence of voltage is only permissible with a suitable (2-pole)
voltage tester / voltage measuring system which fulfills the requirements
specified in EN 61243-3.
• United Kingdom:
If the instrument is being used to determine the presence or absence of
hazardous voltages, always prove the operation of voltage measurement
function before and after use by means of a known voltage source or proving
unit.
• Always ensure that the circuit or appliance under test is electrically isolated.
• The instrument may apply a test voltage or mains power to the appliance under
test. Do not touch the appliance while tests/measurements are active.
Operating Conditions
• Do not use the instrument and its accessories after long periods of storage under
unfavorable conditions (e.g. humidity, dust or extreme temperature).
• Do not use the instrument and its accessories after extraordinary stressing due to
transport.
• Do not expose the instrument to direct sunlight for longer periods of time.
Overheating may cause damage to the device.
• Only use the instrument and its accessories within the limits of the specified
technical data and conditions (ambient conditions, IP protection code,
measuring category etc.).
• Do not use the instrument in potentially explosive atmospheres. Danger of
explosion!
• Do not use the instrument in atmospheres subject to fire hazard. Danger of fire!
• Implement adequate measures for protection against electrostatic discharge
(ESD).