What to do if the display "tEMP" appears on Seca 644 Scales?
If the display "tEMP" appears on the Seca Scales, it means that the ambient temperature of the scale is either too high or too low. To fix this, set up the scale in an ambient temperature between +10 °C and +40 °C. Alternatively, wait for around 15 minutes until the device has adapted to the ambient temperature.
How to fix Seca Scales when no weight is displayed with a load?
If no weight is displayed on your Seca Scales when there is a load on it, check whether the scale is switched on.
Why does '0.00' not appear on Seca 644 before weighing?
If 0.00 does not appear on your Seca Scales before weighing, it could be because a load was already on the scale before it was switched on. Remove the load from the scale. Another reason could be an unspecified error, so try switching the scale off and back on again.
What to do if Seca Scales display 'StOP'?
If the display on your Seca Scales shows "StOP", it means the maximum load has been exceeded. Remove some of the load from the scale.
What does 'tEMP' mean on Seca 644 Scales display?
If the display on your Seca Scales shows "tEMP", the ambient temperature is too high or too low. Set up the scale in a location where the ambient temperature is between +10 °C and +40 °C, and wait approximately 15 minutes for the device to adapt to the ambient temperature.
Why are measurement results transmitted with two beeps after switching on Seca 644 Scales?
After switching on your Seca Scales, if measurement results are transmitted and two beeps are heard, it could be due to a failure to send measurement results to the wireless receiver or interference from HF equipment. Make sure the scale is integrated into the wireless network and the receiver is switched on. Also, keep HF equipment at least 1 meter away from the transmitters and receivers.
Identifies issues when the scale fails to power on or initiate operation.
Addresses problems with inaccurate, missing, or fluctuating weight readings.
Lists specific error codes encountered during the weighing process.
Details the steps to switch to and perform recalibration mode.
Outlines the requirements and steps for PC-based diagnosis or recalibration.
General| Graduation | 100 g |
|---|---|
| Display | LCD |
| Functions | TARE, HOLD, BMI |
| Power Supply | Batteries |
| Type | Digital medical scale |
| Capacity | 300 kg |
To Next Page
