How to fix Seca 644 when no weight is displayed?
If no weight is displayed on your Seca Scales when there is a load, the scale may not be switched on. Check to ensure that the scale has power and is turned on.
What does 'Er:X:12' mean on Seca 644 Scales?
If the display on your Seca Scales shows "Er:X:12", it means the scale was switched on with too high a load. Remove the load from the scale and then restart it.
What does error code 'Er:X:11' mean on Seca 644?
If the display on your Seca Scales shows "Er:X:11", it indicates that the scale has too high a load or too much load in one corner. Remove some of the load, distribute the weight more evenly, and restart the scale.
Why doesn't '0.00' appear on my Seca 644 Scales before weighing?
If '0.00' does not appear on your Seca Scales before weighing, it might be because a load was already on the scale when it was switched on. Remove the load, switch the scale off, and then switch it back on.
What does battery symbol mean on Seca 644 Scales display?
If the display on your Seca Scales appears , it means the battery block power is running down. Recharge the battery block as soon as possible.
What does 'bAtt' mean on Seca 644 Scales display?
If the display on your Seca Scales shows "bAtt", it means the battery block is discharged. Charge the battery block.
What does error 'Er:X:16' mean on Seca 644 Scales?
If the display on your Seca Scales shows "Er:X:16", it means the scale was caused to oscillate, and the zero point could not be determined. Restart the scale.
What to do if the display "StOP" appears on Seca Scales?
The display "StOP" indicates that the maximum load for the Seca Scales has been exceeded. To resolve this, remove the load from the scale.
Why does the display "bAtt" appear on Seca 644 Scales?
The display "bAtt" on your Seca Scales indicates that the battery block is discharged. To solve this, charge the battery block.
Why do Seca Scales transmit measurement results and beep after the first switch on?
If, after switching on for the first time, measurement results are transmitted and two beeps are heard on your Seca Scales, it means that the device was unable to send measurement results to the wireless receiver. Ensure that the scale is integrated in the wireless network and that the receiver is switched on. Also, keep HF equipment at least 1 meter away from transmitters and receivers in the Seca wireless network. NOTE If this fault is not eliminated, there will be no fresh acoustic warning when further attempts are made to send data.
General| Graduation | 100 g |
|---|---|
| Display | LCD |
| Functions | TARE, HOLD, BMI |
| Power Supply | Batteries |
| Type | Digital medical scale |
| Capacity | 300 kg |
To Next Page
