Operation • 79
Automatic switching of
weighing range
The scale has two weighing ranges. In weighing range
1 ( ), capacity is reduced, but the increments in the
weight display are finer. In weighing range 2 ( ), you
can use the maximum capacity of the scale.
After the scale is switched on, weighing range 1 is
active. If a particular weight is exceeded, the scale
automatically switches to weighing range 2.
To switch back to weighing range 1, proceed as
follows.
► Completely remove the load from the scale.
Weighing range 1 is active again.
Switching off the scale
► Press the Start key.
NOTE
In rechargeable battery operation, the scale
switches off automatically after a short time if
there is no load on it.
To Next Page
Loading...
