Seca 665 - Setting the Time (Time)

90 •
2. Select the "APrt" menu item from the "rF" submenu
and confirm your selection.
3. Select the setting relevant for your device
combination:
– HI: measurement results from length
measuring devices
– MA: measurement results from scales
– HI_MA: measurement results from length
measuring devices and scales
– Off: no automatic printing, printing only pos-
sible by pressing and holding the Enter key
during the weighing procedure.
4. Confirm your selection.
You exit the menu automatically.
Setting the time (Time) You can configure the system so that the wireless
printer automatically adds a date and time to your
measurement results. To do this, you have to set date
and time once on this device and transmit it to the
internal clock of the wireless printer.
NOTE
This function is only accessible if a
seca wireless printer has been integrated in the
wireless group via the "learn" function.
1. Switch on the device.
2. Select the "tIME" menu item from the "rF"
submenu.
3. Confirm your selection.
The current setting for "Year" (YEA) is displayed.
4. Set the correct year.
5. Confirm your selection.
6. Repeat steps 3. and 4. accordingly for "month"
(Mon), "day" (dAy), "hour" (hour) and "minute"
(Min).
7. Confirm each of your selections.
After confirming the setting for minute, you
automatically exit the menu.
The settings are automatically transmitted to the
wireless printer.
The wireless printer automatically adds a date and
time to every printout.