Operation • 61
5. Read off the measured result.
The additional weight has been deducted
automatically.
6. To disable the TARE function, press the (hold/tare)
arrow key until the message “NET” is no longer dis-
played or switch off the scale.
NOTE
The maximum weight which can be displayed is
reduced by the weight of the objects already
placed on the scale.
Continuous display of
measured result (HOLD)
If you activate the HOLD function, the weight value
continues to be displayed after the load has been
removed from the scale. This allows you to attend to
the baby before noting down the weight.
1. Place the load on the scale.
2. Briefly press the (hold/tare) arrow key.
The display flashes until a stable weight is meas-
ured. The weight value is then displayed continu-
ously. The symbol (non-calibratable function) and
the message “HOLD” are displayed.
3. To disable the HOLD function, briefly press the
(hold/tare) arrow key.
The symbol and the “HOLD” message are no
longer displayed. 0.000 appears in the display. You
can perform another weighing operation if required.
NOTE
If the Autohold function is activated, the
weighed value will automatically be displayed
continuously (see section entitled “Activating
the Autohold function (Ahold)” on page 63).
Transmitting measured
results to wireless
receivers
If the scale is integrated in a seca 360° wireless net-
work, you can transmit the measured results to
receive-ready equipment (wireless printer, PC with USB
wireless adapter) at the touch of a button.
Press the (send/print) Enter key.
– Press key briefly: send measured results to all
receive-ready devices
– Hold down: print out measured result on
wireless printer
To Next Page
Loading...
