66 •
3. Confirm your selection.
You exit the menu automatically.
Restoring factory
settings (RESET)
You can restore the factory settings for the following
functions:
NOTE
The wireless module is switched off when fac-
tory settings are restored. Information about
existing wireless groups is retained. Wireless
groups do not have to be set up again.
1. Select the “rESEt” item from the menu.
2. Confirm the selection.
You exit the menu automatically.
3. Switch off the scale.
Factory settings are restored and are available
when the scale is next switched on.
7. THE SECA 360° WIRELESS NETWORK
7.1 Introduction
This device is equipped with a wireless module. The
wireless module allows measured results to be trans-
mitted wirelessly for analysis and documentation. Data
can be transmitted to the following devices:
• seca wireless printer
• PC with seca USB wireless adapter
seca wireless groups The seca 360° wireless network operates with wire-
less groups. A wireless group is a virtual group of trans-
mitters and receivers. If you wish to operate several
transmitters and receivers of the same type, up to 3
wireless groups (0, 1, 2) can be set up.
Function Factory setting
Autohold (AhoLd)
depending on
model
Acoustic signal (PrESS) Off
Acoustic signal (HoLd) On
Attenuation (FiL) 1
Wireless module (SYS) Off
Autosend (ASEnd) Off
Autoprint (APrt) Off
To Next Page
Loading...
