Seca 727 - Activating Automatic Transmission (Asend)

70 •
The device suggests a channel number for channel
3 (here: “C360”).
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
10. Confirm your selection for channel 3.
The “StOP” message appears in the display.
The device is waiting for signals from other devices
with wireless transmission capability within range.
NOTE
With certain devices, a special switch-on proce-
dure must be followed if they are to be inte-
grated in a wireless group. Follow the
instructions for use for each device.
11. Switch on the device you wish to integrate in the
wireless group, e.g. a wireless printer.
A beep can be heard when the wireless printer is
detected.
NOTE
As soon as you have integrated a wireless
printer in the wireless group, you must then
select a print option (menu\rF\APrt) and set the
time (menu\rF\tiME).
12. Repeat step 11. for all devices you wish to integrate
in this wireless group.
13. Press the Enter key to end the search.
14. Press the arrow key to see which devices have
been detected (here: “MO 3” for a wireless printer).
Once you have integrated several devices in the
wireless group, press the arrow key several times to
ensure that all devices have been detected by the
scale.
15. Press the Enter key to exit the menu or wait until
you exit the menu automatically.
Activating automatic
transmission (ASend)
You can configure the device so that the measured
results are automatically transmitted to all receive-
ready receivers registered to the same wireless group
(e.g.: wireless printer, PC with USB wireless adapter).
NOTE
If you are using a wireless printer, ensure that
the print option is not switched to “Off” (“Select-
ing print option (APrt)” on page 71).