64 •
Activating acoustic
signals (BEEP)
You can set whether an acoustic signal is to be emitted
whenever a key is pressed or a stable weight value has
been attained. The latter is relevant for the Hold/Auto-
hold function.
NOTE
The function “Acoustic signal when weighing
value is stable” is activated at the factory. If
required, you can disable this function.
1. Select the “bEEP” item from the menu.
2. Confirm the selection.
3. Select a menu item
– PrESS: acoustic signal whenever a key is
pressed
– HOLd: acoustic signal when weighing value is
stable
4. Confirm your selection.
The current setting is displayed.
5. Select the setting you require:
–On
–Off
6. Confirm your selection.
You exit the menu automatically.
7. If you also wish to activate the acoustic signals for
the second function, repeat this process.
Select attenuation (FiL) You can use attenuation (Fil = filter) to reduce any inter-
ference during weighing (e.g. caused by patient move-
ments).
1. Select the “Fil” item from the menu.
2. Confirm the selection.
The current setting is displayed.
3. Select an attenuation level.
– 0: low attenuation
– 1: moderate attenuation
– 2: high attenuation
4. Confirm the selection.
You exit the menu automatically.
To Next Page
Loading...
