Seca 727 - Setting up a Wireless Group (Lrn)

The seca 360° wireless network • 69
English
2. Select the “SYS” menu item from the “rF” sub-
menu.
3. Confirm the selection.
4. Select the “On” setting.
5. Confirm the selection.
You exit the menu automatically.
Setting up a wireless
group (Lrn)
To set up a wireless group proceed as follows.
1. Switch on the device.
2. Call up the menu.
3. Select the item “rF” in the menu.
4. Confirm the selection.
5. Select the “Lrn” (learn) menu item from the “rF”
submenu.
6. Confirm the selection.
The wireless group currently set (here: wireless
group 0 “Id 0”) is displayed.
If wireless group “0” already exists and you wish to
set up another wireless group with this device, use
the arrow key to select a different ID (here: wireless
group 1 “Id 1”).
7. Confirm your selection for the wireless group.
The device suggests a channel number for channel
1 (here: “C1 0”).
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
8. Confirm your selection for channel 1.
The device suggests a channel number for channel
2 (here: “C230”).
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
NOTE
Two-digit channel numbers are displayed with-
out a space. The display “C230” means: chan-
nel “2”, channel number “30”.
9. Confirm your selection for channel 2.