Model 763 25
7. What to do if …
… no weight or height readout appears?
– Is the device switched on?
– Is the plug between the power supply connector in the rod and base properly connect-
ed?
– Is the plug contact of the AC adaptor properly connected on the device rod?
– Is the plug contact for connecting the display and the base properly connected?
… 0.0 does not appear before weighing?
– Press the start button again – there must not be any load on the scales – and only its
feet should be in contact with the floor.
… one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
… St0P appears in the weight display?
– Maximum load has been exceeded.
… the weight display is blinking?
– If you have just activated the Hold or Tare function, please wait until the scales have
detected a steady weight value. The display will then stop flashing.
– If there has been no activation of a function beforehand, remove the load from the
scales and wait until 0.0 is displayed, then weigh again.
… the display appears?
– The ambient temperature of the device is too high or too low. Place the device where
the ambient temperature is between +10 ˚C and +40 ˚C. Wait about 15 minutes until
the device has adjusted to the ambient temperature and weigh again.
… the display and a number appear?
– Use the Start button to switch off the device and start again. After this the device will
function normally.
– If this is not the case, disconnect the power supply by briefly unplugging the AC adap-
tor. If this measure is equally unsuccessful, inform the Service department.
… appears in the height display?
– Slide the head slide up or down quite a ways. This will make the head slide pass a mark
which can be evaluated and the system can now calculate the position correctly again.
www.scaleman.com is your Authorized Seca Dealer
www.balances.com is your Authorized Seca Dealer
To Next Page
Loading...
