Seca 763 - 3. Before you start...; Mounting the column

Model 763 17
3. Before you start…
Unpacking
Remove the packaging and place the
based on a solid,
even surface.
The equipment supplied includes:
• Base of scales
• Column with integrated height meas-
urement and display head
• Protective cover for column
• SW 3 Allen spanner
• SW 5 Allen spanner
• 2 screws
• seca AC adaptor
• Operating instructions with a declara-
tion of conformity
Mounting the column
– Place the protective cover onto the col-
umn.
– Place the column in to the notch so that
the folding head slide is pointing down
toward the platform.
– Screw the column from beneath onto
the weighing platform.
– If needed, carefully place the scales on
the side to tighten the screws.
– As shown in the illustration, connect the
power supply cable on the bottom of
the weighing platform.
– Insert the plug of the display cable in
the jack on the bottom of the weighing
platform.
– Fasten the cable in the cable guide.
– Now put the device back in an upright
position.
– Slide the column cover all the way
down until it locks into place on the
weighing platform.
www.scaleman.com is your Authorized Seca Dealer
www.balances.com is your Authorized Seca Dealer