38 • seca 874 +
5.2 Establishing power supply
Inserting batteries
You need 2 batteries (type AA/1.5 V, included in scope of delivery).
1. Open the cover of the battery compartment.
NOTICE!
Damage to device
Device may overheat and become damaged.
► Ensure the correct polarity of the batteries (markings in the battery
holder).
2. Insert the batteries.
3. Close the battery compartment.
Connecting the power pack (optional)
The scale can be operated with a power pack (optional accessory).
WARNING!
Personal injury or damage to the device as a result of incorrect power
supply units
Conventional power supply units may deliver a higher voltage than is
indicated on them. The measuring device may overheat, catch fire,
melt or short-circuit.
► Use only original seca power supply units with a controlled 12 V
output voltage.
1. Insert the connector required for your power supply into the power supply
unit.
2. Insert the device connector of the power supply unit into the connecting
socket of the scale.
3. Plug the power supply unit into a power supply socket.
NOTICE!
Faulty measurement
► Do not pull on the power cable during measurements.
17-10-06-648-100b_2024-05S
To Next Page
Loading...
