SEDEMAC GC1100 - Figure 7: Fixing Clip and Screw Supplied Along with Controller; Figure 8: Controller Mounting on the Panel Using the Fixing Clips

To Next Page

To Previous Page

GC1100 SEDEMAC

Page | 11

Figure 7: Fixing clip and screw supplied along with controller

Figure 8: Controller mounting on the panel using the fixing clips

• Insert the fixing clip into the slot provided on the side of the controller.

• Pull the fixing clips backwards (towards the back of the module). Ensure that the fixing clip is

properly fitted inside the slot provided on the controller.

• Fix the screws and tighten the screw (turn clockwise) to mount the controller properly into the

panel. Ensure that the screw will be always perpendicular to the panel surface. The maximum

tightening torque is 0.19 N-m.

Over tightening of the screws may damage the controller casing.