Set the time interval when in moving state ： text the
command:#password#MVUP#seconds# to the device’s SIM card
number
Succeeding reply：set movement upload time, OK! Failure reply：Format
wrong!
For example, if you want to set the time interval of moving state as 12
seconds，text the command：#8888#MVUP#12#
Note：the default is 10 seconds. Only admin and authorized number can
operate.
Cancel continuous location：text the command:#password#NOUP# to
the device’s SIM card number
Succeeding reply：close upload GPS information,OK！ Failure reply：
Format wrong!
Note：Only admin and authorized number can operate.
8.5 Cut off and resume the oil circuit
Cut off the oil circuit：text the command:#password#STOP# to the
device’s SIM card number,
Succeeding reply：please waitting,When speed < 20 to break the car
oil,Otherwise need to speed < 20 only enter into processing! Then
reply：Fuel cut has already been completed,OK!
Failure reply：Format error!
Note：Only admin and authorized number can operate.
Resume oil circuit ： text the command: #password#RUN#to the
device’s SIM card number
Succeeding reply：Resume fuel, OK! Failure reply：Format wrong!
Note：Only admin and authorized number can operate. In order to ensure
the safety of derivers, the device only cut off the oil circuit on the
condition of the driving speed below 20KM/H or in static state. When the
vehicle speed is over 20KM/H, the device will cut off the oil or the power
when the speed below 20KM/H.
8.6 Set or cancel the over speed alarm
Set the over speed alarm ： text the
command:#password#SOSA#speed# to the device’s SIM card
number
Succeeding reply： Set speed alarm，OK! Failure reply：Format wrong!
For example, if you want to set the over speed alarm at 120Km/h,please
text the command：#8888#SOSA#120#
Note：Only admin and authorized number can operate.
To Next Page
Loading...
