53
TEST MODE
12
● CLEAN ROLLER
Clean each type of roller used to deliver cards.
Choose this option and UNIT STATUS will display “CLEANING UNIT ROLLER”.
Insert a cleaning card to clean each type of roller.
When the operation is complete, the cleaning card is ejected. Remove the card to fi nish the cleaning.
● CLEAN STOCKER
Clean the stocker’s card dispenser rollers.
Empty the stocker before cleaning. Place a cleaning card in the stocker and close the lid.
Choose this option and UNIT STATUS will display “CLEANING STOCKER ROLLER”. The roller cleaning will then
begin. Cleaning is complete when UNIT STATUS displays “DONE”.
Remove the cleaning card from the stocker and replace the card stock.
● ERASE PRINT
Choose this option and UNIT STATUS will display “INSERT CARD”.
Insert a printed card. UNIT STATUS will display “ERASING...” and the print erase process will begin. Erasing is com-
plete when UNIT STATUS displays “EJECTED. REMOVE THE CARD”. Remove the card.
NOTE: This only tests the print erase function. It does not affect card data.
If an error occurs during a check, UNIT RESULT may display one of the following messages.
CARD JAM: The card is stuck
SHUTTER ERROR: Shutter error
PRINTER ERROR: Printer error
UNIT ERROR: Unit error
UNKNOWN ERROR: Unknown error
READ ERROR: Read error
CARD EMPTY: There are no cards in the stocker
SENSOR (***) indicates the status of the sensors.
It displays the status of the card sensors on the card reader/writer and printer.
Select IC CARD RESTORATION to attempt to restore IC card data using backup data saved on the cabinet.
The cabinet will save up to 10 data fi les that were not properly transferred to IC cards due to accidental power out-
ages during play, card write failures, or card data transfer failures.
NOTES:
- Each new fi le beyond the 10th will overwrite the oldest existing fi le.
- IC card restoration is only possible if backup data is saved on the cabinet. It is not possible to restore IC cards
containing data that was damaged while playing on other cabinets.
12-3-9 IC CARD RESTORATION
Restoring IC cards after renewal failure
An old IC card is ejected as “EXPIRED”, but the game
freezes or the power fails before the new IC card renew-
al process begins.
The old card’s access code is displayed under SELECT
ACCESS CODE (marked with a “*” on the right side).
Insert the card with “EXPIRED” printed on it to restore
the card to its pre-renewal status and start the renewal
process over on the game cabinet.
A problem occurs while creating the new IC card and
the write process is interrupted.
The new IC card’s access code is displayed under SE-
LECT ACCESS CODE. Insert the new IC card and try
to restore it.
IC CARD RESTORATION
SELECT ACCESS CODE : [****-****-****-**** (*/*)]
RESTORE
EXIT
STATUS : ---
RESULT : ---
SELECT WITH SERVICE BUTTON
AND
PRESS TEST BUTTON
To Next Page
Loading...
Need help?
General
