EasyManua.ls Logo

Sega Showdown - Troubleshooting Guide; Troubleshooting Without Error Messages

Sega Showdown
141 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING
15
91
TROUBLESHOOTING
15
15-1
TROUBLESHOOTING (WHEN NO ERROR MESSAGE IS SHOWN)
• Inordertopreventelectricshock and short circuit, be sure to turn poweroff
beforeperformingwork.
• Becareful soasnotto damagewirings.Damaged wiringcancauseelectric
shockorshortcircuit.
• AfterremovingthecauseofthefunctioningoftheCircuitProtector,reinstate
theCircuitProtector.Dependingonthecauseofthefunctioning,usingtheCircuit
Protectorasiswithoutremovingthecausecancausegenerationofheatandre
hazard.
• Intheeventthataproblemcannotberesolvedbyemployingtheprocedures
listedinthisManual,besuretorequestservicefromtheofficeshownonthis
Manualorthedealerfromwhomtheproductwasoriginallypurchased.Attempts
toemployproceduresotherthanthosespecifiedinthisManualcancause
electricalshock,shorting,orre.
• Intheevent of a problem that is notdescribedhere,besuretocontactthe
ofceshownonthisManualorthedealerfromwhomtheproductwasoriginally
purchased.Carelessattemptsatrepaircanresultinelectricalshock,shorting,or
re.
If a problem occurs, rst check to make sure that the wiring connectors are properly connected.
15 TABLE 01
PROBLEM CAUSE COUNTERMEASURES
When the main SW is
turned ON, the machine
is not activated.
The power is not ON. Firmly insert the plug into the outlet.
Incorrect power source/voltage. Make sure that the power supply/voltage
are correct.
The Fuse on the AC Unit has blown
due to momentary over current.
After eliminating the cause of overload,
replace the specied rating fuse.
The fuse of the connect board has
blown due to momentary over
current.
After eliminating the cause of overload,
replace the specied rating fuse.
LED lamp inside
Billboard Unit not
lighting
Connector connection fault. Check connections to the Billboard Unit.
Replace LED strip Replace LED strip
To Purchase This Item, Please Visit : BMIGaming.com | Call Global Sales : + 561.391.7200 | USA / CA : (800) 746-2255

Related product manuals