Sega Showdown - Controller Unit Maintenance

CONTROL UNIT
59
10
• Whenworkingwiththeproduct,besuretoturnthepoweroff.Workingwiththe
poweronmaycauseanelectricshockorshortcircuit.
• Becarefulnottodamagethewires.Damagedwiresmaycauseanelectric
shock,shortcircuitorpresentariskofre.
• Exerciseduecautioninperformingsolderingwork.Ifsolderingironishandled
carelessly,therecouldberesorburns.
• Whenfasteningplasticparts,becarefulnottotightenscrewsornutsexcessively.
Ifthesearetightenedtoexcess,partscouldbedamaged,resultingininjuries
fromfragments,etc.
• Aftertheunithasbeendisassembledandreassembledagain,checkcarefully
thattheunithasbeenreassembledcorrectly.
• Besuretoinspecttheoutercoversonbothgearandhandbrakeunits.
• AssemblesothatthereisnogapbetweentheLandRcovers.Ifthereisagap
orrattling,theplayerscouldgetngersorhandscaught,resultingininjury.
• Oncetheproducthasbeendisassembled,useslackpreventiveagent(product
No.:090-0012-N).Coatscrewswithsuitableamountsofthisagentandthen
tightenthem.Ifthisagentisnotused,theproductmightstartrattlingorcome
apart.
• Usetheslackpreventiveagentprescribedintheseinstructions.Ifanyother
agentisused,therecouldbechemicalchangesthatinhibittheuseofscrews
andpartsurfacescouldbedamaged.
• Becarefulnottodamageorlosesmallpartsorscrews.
• Whenaparthasbeenreplaced,besuretoalwaysmakeadjustmentsand
checkconditionsinTestMode.
10 CONTROLLER UNIT(S)
To Purchase This Item, Please Visit : BMIGaming.com | Call Global Sales : + 561.391.7200 | USA / CA : (800) 746-2255