Segway FUGLEMAN SGW1000F-U2 - Page 103

O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
91
Remove the Remote control from the passenger´s armrest and
connect it to the receptacle in the dash panel.
1. Open the waterproof cover of the receptacle.
2. Insert control switch connector into the receptacle.
Remote control
1
Release the winch rope
2
Recoil the winch rope
When the winch is needed, the rope should be aligned with the
vehicle, preferably in a straight line. Too sharp angle will change
the direction of tension and damage the rope. In case of serious
noise or vibration during the use of the winch, stop the winch
immediately.
If the remote control doesn’t work, it may happen that the battery
in the remote control is flat.
Replace the battery with a new one in such case.
NOTICE