Segway PT Product Orientation > i2 > x2
Page 13 of 29 p/n __________________
Coach’s Manual © Segway Inc. 2015 All rights reserved
Understanding the Rider Detect Sensors
The Segway PT has four sensors located beneath the
Mats. Rider Detect Sensors detect the presence or
absence of a rider while the Segway PT is powered
on.
When your feet are properly positioned on the Mats,
all four Rider Detect sensors depress, allowing the
Segway PT to operate normally in Balance Mode.
If fewer than three Rider Detect sensors are
depressed while riding, the Segway PT reduces the
top speed limit regardless of whether Beginner Setting
is enabled or not. Once your feet are properly
positioned again, the Segway PT regains full
performance.
Show Rider Detect Sensor
positions by pointing to Mats and
showing the locations.
If the Segway PT is moved too quickly while in
Balance Mode and none of the Rider Detect Sensors
are depressed, the Segway PT will give the Stick
Shake Warning before exiting Balance Mode and
transitioning to Standby Mode.
Demonstrate moving Segway PT
too quickly while in Riderless
Balance Mode, until Shtick Shake
Warning occurs followed by
Standby Mode after five feet.
To Next Page
Loading...
