Segway x2 SE - InfoKey Controller and Dock Procedures

Segway PT Product Orientation > i2 > x2
Page 21 of 29 p/n __________________
Coach’s Manual © Segway Inc. 2015 All rights reserved
Step 9: Stepping Off
Remain stationary by keeping your weight centered
over the Wheels and Powerbase and keep the
Handlebar vertical.
Hold the Handlebar as Rider steps
off. Correct if Rider
pushes/pulls/turns while stepping
off.
To step off the Segway PT:
To step off the Segway PT remove one hand from the
handlebar and loosen the other hands grip.
Without leaning backward or to the side, step off the
Segway PT, one foot at a time. Remember to remove
both feet completely from the Segway PT.
After you have stepped off, continue to hold the
Handlebar in place. If you let go, the Segway PT will
roll forward and can potentially cause injury or
damage.
When you step off, the Segway PT enters Riderless
Balance Mode. In Riderless Balance Mode, the
Segway PT moves forward, backward and turns in
response to how you move the Handlebar. Use
Riderless Balance Mode to move the Segway PT over
curbs or terrain where it is unsafe or undesirable to
ride.
Spot closely.
Point out Balance Indicator Light
and InfoKey Controller Display
after Rider steps off.