Segway PT Product Orientation > i2 > x2
Page 18 of 29 p/n __________________
Coach’s Manual © Segway Inc. 2015 All rights reserved
Step 3: Confirming the Beginner Setting
Ensure that the Beginner Setting is enabled by
confirming that the Turtle icon shows on the InfoKey
Controller display.
For additional information on what to do if you do not
see the Turtle icon on the InfoKey Controller display,
see “Configuring and Locking the Beginner Setting” in
the User Manual.
Point out Turtle Icon. Explain that
Beginner Setting is locked and
they can unlock it when they are
ready by following instructions in
User Manual.
Step 4: Before Stepping On
Your Segway PT is on, but it is not balancing. While
standing behind the Segway PT, center the Handlebar
and level the Powerbase. If any of the four outer
Balance Indicator lights are red, tilt the Powerbase or
Handlebar in the opposite direction of the light(s).
When the Segway PT is ready to enter Balance
Mode, the center Balance Indicator light will light up
green. While the center balance indicator light is
green, touch the footpad once to enable riderless
balance mode. Make sure your InfoKey Controller is
installed in the Dock prior to stepping on.
When the center Balance Indicator light is green, the
Segway PT is ready for you to step onto the Mats.
Move LeanSteer frame around
showing how Balance Indicator
Lights correspond. Then center
and point out Green center
Balance Indicator Light.
To Next Page
Loading...
