22
■ Cutter Error Treatment
When the cutter is locked during paper cutting due to a cutter error and the paper cover does not open,
recover the printer according to the following procedure.
Turn off the printer. (1)
NOTE
◆
Be sure to turn off the printer before handling a cutter error.
By operating the release lever repeatedly to the end while holding the paper cover, the cutter blade (2)
returns to the home position. And then, the paper cover can be open. When a paper jam occurs,
remove it.
Set the thermal paper straight and then close the paper cover gently. (3)
Turn on the printer. (4)
When the printer is recovered normally, the LED turns blue. (5)
NOTE
◆
DO NOT use such as ballpoint pens, drivers, and cutter knives to remove a paper jam.
Be careful not to damage the printer.
Especially, do not touch the thermal head because it is easy to break.
◆
Be careful not to cut your fingers or be injured by the cutter blade.
◆
DO NOT apply excessive force on the cutter blade.
To Next Page
Loading...
Need help?
General
