Liquid Crystal Display
(1)
(2)
(3)
- By pressing F/W key, the
indicated symbol will be
converted from F to EV,
and vice versa.
When the meter is used
in the flash mode, only
the F mark is displayed.
Display for film speed
-
moves through a range of
IS0 3 - IS0 8000 by
pressing either UP or
DOWN key while holding
the IS0 key depressed.
Symbol for wireless measurement 01, wired
measurement Ioc or tine mode C will be dis
played depending on the mode selection.
In case of ambient light measurement (excepting
tine mode), no symbol is indicated here.
aoa*a~mea*aoaoa
8 11 1622324564900
F-stop number is also dis-
played in bar-dot symbols
at 112 F-stop increments.
s mark appears when
the measuring range is
exceeded (underexposure).
5 mark appears when
the measuring range is
exceeded (overexposure).
(1) Bar symbols indicate
the fractions of F-stop
or EV.
(2) Battery capacity is
shown when the meter
is switched on.
Shutter speed (T) is
shown in this display.
Digital value of F-stop or EV measurement is
shown in this display (f/l -f/90 or EV -6- EV 25).
b.c. (battery check) mark is displayed when
For ambient light:
30 min. - l/8000 sec.
For flash light:
1 sec. - 11500 sec.
the meter is switched on.
E.u. (underexposure) or E.o. (overexposure)
mark is displayed when the measuring range
is exceeded.
For tine camera:
8, 16, 18, 24, 32, 64
and 128 fps.
2
To Next Page
Loading...
