Preparin
the Meter for Operation
1. Inserting the battery
The meter uses a single AA size pen-light battery
(1.5h. Open the battery chamber cover by sliding it in
the direction of arrow, and insert the battery carefully
aligning (+) and (-) polarities as indicated inside the
chamber.
Note: When not using the meter for a week or
more, remove the battery from the meter.
This will prevent any internal damage
arising from battery leakage.
2. Checking the battery
Check the battery before using the meter. A weak
battery will not assure the correct light readings.
Slide the power switch to ON position. Then the b.c.
mark and bar symbols will be displayed. Battery
capacity is indicated by the bar symbols (Fig. 1).
After checking battery (for about 0.5 sec.) the display
automatically changes to measuring mode (Fig. 2). If
the battery is too weak to give a correct light
readings, the b.c. mark will flash.
Note: If you switch the meter on while depressing
ISO key, the display of b.c. mark and bar
symbols will keep indicating.
3
3. Selecting measuring mode
Power on and slide the mode selection
switch to the position you want; wireless
measurement for flash light
measurement for flash li
ht
wired or
am
bient light measurement
To Next Page
Loading...
Need help?
General
