Sekonic SR-430 - 10-B a Mode (1-Byte Fixed Output Command)

-40-
Y YYYYY X XXXXX
1 1111

1
0 00000 2 22222 3 33333 4 44444 5 55555 6 66666 7 77777 8 88888 9 99999
10-B AMode(1-byteFixedOutputCommand)
[Explanation]
Thiscommandisforoutputtingthenumberatamarkwhenamarkisdetectedonthe9to0linesin
onecolumnoroutputsaspacewhennomarkormorethantwomarksaredetected.Thisdevice
neglectsmarksandprintsontheXandYlinesandoutputsdataasa1-bytefixedlengthASCIIcode
foronecolumn.
SeparatorslikeSTXandETXcanbeaddedusingtheDC4command.
Note:
Thismodeisenabledonlywiththe12-lineformatsetting.
Example
ASCIIoutputdataforthefollowingmarks
1stcolumn 2ndcolumn 3rdcolumn 4thcolumn
Outputdata ASCIIcode 0 1 SP 2
HEXcode 30H 31H 20H 32H
[Format]
HostCompute Thisdevice
DLE A N1N2N3 M1M2M3 CR Receive
(10H) (41H) (0DH)
Receive Dataoutput
###･････#####
Fixedlengthof1byteacolumnxM1M2M3columns
N1N2N3:3-byteASCIIcodeindicatingreadstartcolumnnumber
(Example)Fromthe3rdcolumn=003(30H,30H,33H)
M1M2M3:3-byteASCIIcodeindicatingnumberofcolumnstoberead
(Example)50columns=050(30H,35H,30H)
Note:
N1N2N3 and M1M2M3 cannot be omitted as 6-byte fixed length data.
10.DataTransferMode