Sekonic SR-430 - 10-G ED Mode(Variable Length Output Command with Density Data)

-45-
10-G EDMode(VariableLengthOutputCommandwithDensityData)
[Explanation]
ThedataformatisthesameastheoneintheEmode.
Onebyteindicatingdensitydataisaddedaftereachmarkdatatooutputitintwobyteunits.
SeparatorslikeSTXandETXcanbeaddedusingtheDC4command.
[Format]
HostComputer Thisdevice
DLE E D N1N2N3 M1M2M3 CR Receive
(10H) (45H)(44H) (0DH)
Receive Dataoutput
##CR･･##CR##CR
Dataofnumberofmarksx2bytes+CRacolumnxM1M2M3columns
N1N2N3:3-byteASCIIcodeindicatingreadstartcolumnnumber.
(Example)Fromthe3rdcolumn=003(30H,30H,33H)
M1M2M3:3-byteASCIIcodeindicatingnumberofcolumnstoberead.
(Example)50columns=050(30H,35H,30H)
Note:
N1N2N3andM1M2M3cannotbeomittedas6-bytefixedlengthdata.
AcolumnwithoutamarkishandledasspaceCR(20H,0DH).
[Example]
Whenthereareamarkofdensitylevel2atposition9andoneofdensitylevel3atposition1,dataof
onecolumntobesentfromthedeviceisasfollows:
HEXcode : (39H) (32H) (31H) (33H) (0DH)
Data : 9 2 1 3 CR
Mark Density Mark Density
Densityinformationoutputdata
*IntheorderofASCIIcode
IntheSR-307compatiblemode,thedensitylevelsof1to8areoutput.
levelytisneD : 1 2 ・・・ 01 11 21 31 41 51 61
atadtuptuO : 1 2 ＠ ？ ＞ ＝ ＜ ； ： ・・・
:edocIICSA（H13（）H23（ ）HA3（）HB3（）HC3（）HD3（）HE3（）HF3（）H04）
10.DataTransferMode