Sekonic SR-430 - Page 51

-42-
[Format]
HostComputer Thisdevice
DLE C A N1N2N3 M1M2M3 CR Receive
(10H) (43H)(41H) (0DH)
Receive Dataoutput
###･････#####
Fixedlengthof3(4)bytesacolumnxM1M2M3columns
N1N2N3:3-byteASCIIcodeindicatingreadstartcolumnnumber
(Example)Fromthe3rdcolumn=003(30H,30H,33H)
M1M2M3:3-byteASCIIcodeindicatingnumberofcolumnstoberead
(Example)50columns=050(30H,35H,30H)
Note:
N1N2N3andM1M2M3cannotbeomittedas6-bytefixedlengthdata.
10-D CAMode(FixedLengthOutputCommandforAutomaticDensityDistinction)
[Explanation]
ThedataformatisthesameastheoneintheCmode.
Thiscommandisforautomaticallydistinguishingmarkdensityforonecolumn.Whenthereare
severalmarks,itcancelslight-coloredmarksoflargerdensitydifferencethanthesetdifferenceand
outputsmarksofsmallerdensitydifferencethanthesetdifference.Sincethedensitydifferenceisset
at01bydefault,thedarkestmarkdataisoutputinthiscase.Densitydifferencebetweenadarkmark
andthenextdarkermarktobecanceledcanbesetusingtheDC3DDcommand.
SeparatorslikeSTXandETXcanbeaddedusingtheDC4command.
Note:Relationshipwithsensitivitylevelsetting
Whenthereisonlyonemark,theexistenceofamarkisdistinguishedaccordingtothepresetsensi-
tivitylevel.
Whenthereareseveralmarks,densitydifferencesarecomparedamongmarksofdensitymorethan
thepresetsensitivitylevel.
Marksofdensitylessthanthepresetsensitivitylevelarecanceled.
Note:
Whenthereareseveralmarksofthesamedensitylevel,dataisalsooutputinapluralform.
10.DataTransferMode