Sekonic SR-430 - Page 59

-50-
-2 TimingMarkCountCheckCommands
ENQTCommand(ReadAreaCountOutputCommand)
[Explanation]
Thiscommandisforreturningthenumberofreadtimingmarks.
Whetheracertainrecordhasadifferenttimingmarkcountornotcanbecheckedbycheckingthe
numberoftimingmarksafterthecardfeedcommand(?command)isissued.
Thedataareof3-bytefixedlengthASCIIcodes.
SeparatorslikeSTXandETXcanbeaddedusingtheDC4command.
[Format]
HostComputer Thisdevice
ENQ T CR Receive
(05H) (54H)(0DH)
Receive Dataoutput
###
Numberoftimingmarks
Example
Whenthenumberoftimingmarksis"64","064"dataisoutput.
Note:
Inthecaseofthemark-to-marktype,thecontentsofdatavaryforeachmode.
SR-430(SR-410compatible)mode:Numberofreadareas
SR-307compatiblemode:Numberoftimingmarks
10.DataTransferMode