Sena MESHPORT RED - Using the Rubber Strap Mount; Attaching the Flat Surface Mount

8
ABOUT THE MESHPORT RED
1.3.2 Using the Rubber Strap Mount
1. Place the rubber strap mount on the object, wind the
rubber band around the object, and hang it on the hook.
2. Attach the rubber strap mount on the back of the main
unit along the guide rail until you hear a click.
1.3.3 Attaching the Flat Surface Mount
1. Locate an appropriate surface for attaching the flat
surface mount, clean the mounting surface with a
moistened towel, and allow it to dry thoroughly.
2. Peel off the cover of the adhesive tape of the flat surface
mount and attach it to the surface.
3. Attach the flat surface mount on the back of the main unit
along the guide rail until you hear a click.
Note: Make sure that the main unit sticks on the surface
firmly. Maximum adhesion occurs after 24 hours.