SC1
5.3.1 A2DP Stereo Music Only
1. To enter the voice configuration menu, press and hold the (+)
Button or the (-) Button for 10 seconds until you hear the
voice prompt, “Configuration menu”.
2. Tap the (+) Button until you hear the voice prompt, “Media
selective pairing”.
3. Search for Bluetooth devices on your smartphone. Select the
SC1 in the list of devices detected on your phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for
the PIN.
5.3.2 HFP for Phone Call Only
1. To enter the voice configuration menu, press and hold the (+)
Button or the (-) Button for 10 seconds until you hear the
voice prompt, “Configuration menu”.
2. Tap the (+) Button until you hear the voice prompt, “Phone
selective pairing”.
3. Search for Bluetooth devices on your smartphone. Select the
SC1 in the list of devices detected on your phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for
the PIN.
14
6 MOBILE PHONE, GPS, SR10
6.1 Mobile Phone Call Making and Answering
1. When you have an incoming call, tap the (+) Button to answer
the call.
2. You can also answer the incoming call by loudly speaking any
word of your choice if Voice Activated Phone Answering (VOX
Phone) is enabled, unless you are connected to intercom.
3. To end a call, press the (+) Button for 2 seconds until you hear a
mid-tone single beep, or wait for the called person to end the call.
4. To reject a call, press the (+) Button for 2 seconds until you
hear a beep while the phone is ringing.
5. There are several ways to make a phone call:
–– Enter numbers on your mobile phone’s keypad and make a
call. Then the call is automatically transferred to the headset.
–– In stand-by mode, press the (+) Button for 3 seconds, to
activate the voice dialing of your mobile phone. For this, the
voice dialing function must be available on the mobile phone.
Refer to your mobile phone manual for further instruction.
To Next Page
Loading...
Need help?
General
