SC1
Note:
1. If you have two phones connected to your headset and you have an
incoming call from the second phone during the call of the first phone,
then you may still receive the call from the second phone. In this case,
the call from the first phone is on waiting mode. If you end a call, then it
will automatically guide you to the first phone call.
2. If you have a mobile phone and a GPS connected to your headset, you
may not be able to listen to the GPS voice instruction during the phone
call.
6.2 Speed Dialing
You can quickly make a phone call by using the voice speed dial
menu.
1. To enter into the voice speed dial menu, press and hold the
(+) Button for 5 seconds and you will hear a mid-tone single
beep and a voice prompt saying “Speed dial”.
2. Tap the (+) Button to navigate between the menus. You will
hear voice prompts for each menu item.
3. Tap the (-) Button to select a voice menu among the followings:
4. After selecting the last number redial menu, you will hear a
voice prompt, “Last number redial”. Then, to redial the last
phone call number, tap the (-) Button.
5. To call one of the speed dials, tap the (+) Button to navigate
between the menus until you hear a voice prompt saying
“Speed dial (#)”. Then, tap the (-) Button.
6. If you want to exit the speed dial immediately, tap the (+) Button
until you hear a voice prompt saying “Cancel”, and tap the (-)
Button. If you do not press any button within 15 seconds, the SC1
will exit the voice speed dial menu and go back to stand-by mode.
Note:
1. Make sure that you connect the mobile phone and the headset to use
the speed dial function.
2. You need to assign speed dial numbers before using the speed dial
(please refer to section 14.6, “Assigning Speed Dial”).
To Next Page
Loading...
Need help?
General
