Audio
221
How can I adjust sensitivity on the transmitter?
• EW-D: You cannot make any settings on the transmitter.
You can adjust the level of the signal coming from the trans-
mitter under the GAIN menu item („GAIN menu item“) on
the receiver.
• EW-DX: In addition to the gain that is set in the receiver („Ch
1 / Ch 2 -> Gain menu item“), you can also set the trim on
the transmitter (EW-DX SKM(-S): „Trim menu item“ | EW-
DX SK (3-PIN): „Trim menu item“) to adjust the sensitivity to
the incoming audio signal.
What is the latency?
• 1.9 ms
Which audio outputs are available on the receiver?
• XLR-3 and 6.3 mm jack (EW-D EM: „Outputting audio sig-
nals“ | EW-DX EM 2: „Outputting audio signals“)
To Next Page
Loading...
