Using the receiver
21
To transfer the parameters:
왘 Switch the transmitter and the receiver on.
왘 Press the button on the receiver.
“Sync” appears on the display panel of the receiver.
왘 Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface of the
receiver.
The parameters are transferred to the transmitter. When the transfer
is completed, “ ” appears on the receiver’s display panel. The receiver
then switches back to the current standard display.
To cancel the transfer:
왘 Press the STANDBY button on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if no
suitable transmitter was found.
To Next Page
Loading...
