Sennheiser flex 5000 - Battery Status and Charging Reminders

Putting the Flex 5000 into operation
Flex 5000 | 17
Displaying the remaining operating time of the
rechargeable battery
When you switch the receiver on, the Battery LED displays the
remaining operating time/charge status.
To indicate that the operating time is decreasing, each LED segment
slowly dims before it goes off completely.
If the actual operating time differs widely from the specified values,
the rechargeable battery is probably exhausted and should be
replaced. Information on the rechargeable battery can be found on
page 26.
Using the charging reminder function
When the receiver is switched off and the transmitter automatically
switches off (standby mode), the
Battery LED will flash back and
forth for 10 minutes to remind you to charge the receiver.
왘 Charge the receiver by placing it into the transmitter’s charging
compartment (see page 16).
The LED stops flashing and the charging process starts.
Always store the receiver in the transmitter’s charging com-
partment to ensure that it is fully charged when needed. The
intelligent battery charging technology prevents overcharg-
ing.
The display during charging can be set so that it automatically
switches off after 30 seconds (see page 29).
Battery LED Meaning
Battery LED
flashes slowly
Rechargeable battery
is empty; recharge it
1
st
LED segment
lit
approx. 4 hours of
operating time
1
st
+ 2
nd
LED
segments lit
approx. 8 hours of
operating time
All LED
segments lit
approx. 12 hours of
operating time
The display of the remaining operating time can be set so that
it automatically switches off after 30 seconds (see page 29).
If more than one receiver is connected to the transmitter, the
remaining operating time/charge status cannot be displayed.
You can also switch off the charging reminder function (see
page 29).