Using additional functions
32 | Flex 5000
Charging the rechargeable battery using the
MCA 800 charging adapter
If you have purchased an additional receiver or an optional MCA 800
charging adapter, you can also charge the receiver using the
charging adapter.
1 Select a suitable country adapter and slide it onto the power
supply unit until it clicks audibly into place.
2 Connect the connector of the power supply unit to the connec-
tion socket of the MCA 800 charging adapter.
3 Plug the power supply unit i
nto the wall socket.
4 Connect the charging adapter to the charging contacts on the
receiver. The charging adapter is magnetically oriented to the
correct position.
The rechargeable battery is being charged. The LED on the
charging adapter lights up red. When the rechargeable battery is
fully charged, the LED lights up green.
If the LED on the charging adapter flashe
s red and green, a charging
error/battery error has occurred. In this case, disconnect the
charging adapter from the receiver. More information on the
rechargeable battery can be found on page 26.
WARNING
Interference due to magnetic fields!
The MCA 800 charging adapter generates stronger permanent mag-
netic fields that could cause interference with cardiac pacemakers
and implanted defibrillators (ICDs).
왘 Always maintain a distance of at least 3.94” (10 cm) between the
holding magnets of the charging adapter and the cardiac pace-
maker or implanted defibrillator.
You can also use the receiver during charging. Please note,
however, that the receiver can get slightly warm during
charging. The charge status of the rechargeable battery is dis-
played on the transmitter (see page 16).
3 h
100 %
US
EU
UK
AU
21
3 4
To Next Page
Loading...
