Sennheiser flex 5000 - Connecting the Transmitter to Power

Putting the Flex 5000 into operation
Flex 5000 | 15
Connecting the transmitter to the power supply
system
1 Connect the connector of the power supply unit to the yellow
socket of the transmitter.
2 Select a suitable country adapter and slide it onto the power
supply unit until it clicks audibly into place.
3 Plug the power supply unit into the wall socket.
All LEDs on the transmitter light up for 5 seconds. The transmit-
ter is in standby mode.
US
EU
UK
AU
2
1
3
Power
1A
1A