SENNHEISER ELECTRONIC GMBH & CO. KG
COMPONENT MAINTENANCE MANUAL
HMEC 26-SERIES
Page 7010
May 25/11
23-41-48
(6) Install the knobs to the PCB:
- Fig. 8, Fig. 10 to Fig. 13: 070 and 080
- Fig. 9: 080 and 090
- Fig. 14 to Fig. 16: 060
(7) Put the PCB in the correct position in the cover (020). Make sure that the slide knobs (30) are
in the correct position related to the potentiometers of the PCB:
- Fig. 14 to Fig. 16: 050
- Fig. 8, Fig. 10 to Fig. 13: 060
- Fig. 9: 070
(8) Install the cover (020) with the relevant PCB and the attached cables on the housing (010).
If there are battery contacts, make sure that they are in the correct position related to the
supports of the housing (010).
(9) Install all relevant inserts at the top and the bottom of the housing (010) and the cover (020).
(10) Install the lens screws into the housing (010) with torque of 23 Ncm ±2Ncm
(with metrical screws max 3 Ncm):
- Fig. 8, Fig. 10 to Fig. 13: 050
- Fig. 9: 060
- Fig. 14, to Fig. 16: 040
(11) Install the labels on the inner or the outer side of the housing (010), if necessary.
Oct 30/08
To Next Page
Loading...
