Sensaphone 800 - Page 27

Sensaphone
®
Model 800 User’s Manual
26
)TISNOTNECESSARYTOHOOKUPATELEPHONEFORTHE-ODEL
TOOPERATE4HISEXTENSIONJACKFEATURES,INE3EIZUREWHICH
MEANSTHATITWILLDISCONNECTTHEEXTENSIONJACKWHENTHE-ODEL
NEEDSTOMAKEATELEPHONECALL4OENSURETHATTHEUNITHAS
priority over any other device on the line, you must connect all
EXTENSIONSTOTHISJACKSEEFIGURE
/NTHEUNITTHEREARETWO2*#PHONEJACKS
s4HE2*#JACKLABELEDh,).%vISTOBECONNECTEDTOTHE
incoming line of your phone service, ahead of all other
PHONESORTELEPHONEEXTENSIONS
s 4HE2*#TELEPHONEJACKLABELEDh%84vISTOBECONNECTED
TOALLEXTENSIONS
7KH0LFURSKRQH
4HE-ODELISPROVIDEDWITHABUILTINMICROPHONEWHICHIS
used to monitor high sound levels produced near the installation
SITE4HESENSITIVITYOFTHEMICROPHONEISCONFIGURABLEAND
WILLDETECTACONTINUOUSASWELLASAPULSATINGALARM.OTE
that beeping alarms that have a half second or more of silence
between beeps will not be detected.
Other programming options that apply to the microphone include
setting the length of time before a high sound causes an alarm.
)FTHISSOUNDLEVELEXISTSFORCONSECUTIVESECONDSDEFAULTORFOR
the programmed length of time, the Model 800 will dial out with
an alarm message.