Need help?Do you have a question about the SENSTAR UltraWave E4FG0101 and is the answer not in the manual?
General| Model | UltraWave E4FG0101 |
|---|---|
| Category | Security Sensors |
| Operating Frequency/Range | 10.525 GHz |
| Environmental Rating/Ingress Protection | IP66 |
| Operating Temperature | -40°C to +70°C |
| Communication Interface | RS-485 |
| Weight | 1.5 kg |
| Detection Technology | Microwave |
| Power Supply | 12-24 VDC |
| Alarm Output | Relay |
Detailed site drawings, zone placement, length, and offsets are critical for optimal performance.
Mounting angle impacts signal strength; offsets prevent undetected intrusions by covering unmonitored areas.
Details system power consumption, input voltages, cable gauge requirements, and essential grounding procedures.
Covers Local, Remote, and Network Manager (NM) modes for transmitting alarm and status information.
Instructions for mounting transmitter and receiver units on posts or surfaces, including alignment aids.
Details power input, output, auxiliary, and ground connections for transmitter and receiver units.
Covers power supply connections and the steps for installing network interface cards for communication.
Illustrates network connections and procedures for stacking multiple UltraWave units.
Connecting the UCM, specifying the operating Locale (FCC/ETSI) for the sensor.
Setting Frequency Pairs, serial numbers, thresholds, and performing receiver calibration.
Procedures for system testing, alignment verification using RSSI, and troubleshooting detection issues.
Recommended procedures for regular inspection, cleaning, and environmental upkeep of the units and site.
Guidelines for beam-break tests, self-tests, and methods to identify and resolve nuisance alarms.
Using received signal strength indicators (RSSI) to check and adjust the alignment of sensor units.
Details power consumption, operating range, beam width, dimensions, and weight of the unit.
Covers operating voltage, carrier frequency, separation distances, and antenna patterns.
Lists the part numbers and descriptions for the sensor system, transmitters, and receivers.
Details network interface cards, data converters, and software required for network connectivity.
Explanation of how UltraLink I/O processors function in Network Manager Mode for sensor data.
Steps to configure UltraWave receiver outputs via UCM for alarm and supervision reporting in NM Mode.
To Next Page