Sentry Sample Sequencer 5 - Page 47

Sentry Equipment Corp | Sample Sequencer

5
SPD 5.5.15 41
6.2.1 Wall Mounting
1. Use the dimension information shown in Figure 40 to mark positions on the wall for four
screw holes. Position the device such that a minimum of two (2) mounting screws mount
to a stud.
2. Drill pilot holes in the marked positions for four ¼ -inch (M6) screws.
3. Use four ¼-inch (M6), hex-head or pan-head screws to secure the device to the wall.
Figure 40: Mounting Dimensions
Figure 41: Wall Mounting the Sample Sequencer