Sentrym L1 - Basic Operations; Powering On and Off; Image Sharpness Adjustment

Powering On:
Powering Off:
Image Sharpness:
Switch the [On/Off] Switch to the “On” state, then press the Power Button to
power on. The Power LED will turn blue and the display will show up shortly.
If the battery power is low, please connect the power adapter to the Power
Input port to charge the projector.
Press the Power Button and you will get a prompt to shutdown the device. Click “OK”,
and once the projector stops running, switch the [On/Off] Switch to the “Off” state to
prevent battery discharge.
To adjust the sharpness of the image, please adjust using the focusing wheel located
on the left of the projector.
1
2
3
L1