Serta Motion Essentials V King - Installation Guide; Step-by-Step Installation Process

8
To install the legs, thread the washer over the screw on the leg. Next,
screw the leg into the nutsert on the frame. Do not over ghten.
The legs untwist into separate secons for custom leg height opons
(3", 6", 9" or 12")
STEP 1
STEP 2
installaon guide
Always use two people when seng up the base, moving or ipping the base.
Place the bed base box in a desired locaon with the boom of the box
facing up.
Remove the binding straps and packing materials, making sure not to
puncture the box with any sharp objects.
Remove the bed base from the box keeping the boom of the base
facing upwards.
STEP 3
STEP 5
STEP 6
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply.
To install headboard brackets (sold separately)
see instructions on page 14.
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure that
the Power Supply and all aached cords are
directed toward the desired surge protector.
For customer support, visit www.ergomoon.com or call: 1-888-550-3746
STEP 4
To sync two bases with the sync cord - see page 13
Locate the baery backup strap.
Store the baery backup strap in a convenient
locaon in case of an emergency power outage.
For operang instrucons, see page 10.