Server Technology switched pro2 - Page 156

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 156
set dhcp
Sets DHCP configuration values.
Command Syntax
set dhcp [disabled | enabled]
set dhcp fqdn [disabled | enabled]
set dhcp fqdn name <name>
set dhcp staticfallback [disabled | enabled]
set dhcp bootdelay [disabled | enabled]
Parameters
The set dhcp command uses the following parameters:
fqdn
Fully-qualified domain name (FQDN).
staticfallback
Falls back to static IP address if DHCP fails.
Note: The staticfallback option does not apply when WLAN is
enabled.
bootdelay
Delays system boot by 100 seconds.
Sub-Parameters
The set dhcp command uses the following sub-parameter:
name
FQDN name. 0-63 characters.
Command Access
Admin level only
set dns
Sets domain name system (DNS) server configuration values.
Command Syntax
set dns [primary | secondary] <ipv4/ipv6>
Parameters
The set dns command uses the following parameters:
primary
Sets the first DNS server. 0-46 characters.
secondary
Sets the secondary DNS server. 0-46 characters.
Command Access
Admin level only; no access in Demo mode