Server Technology Switched Rack PDU - Page 79

Switched PDU
Installation and Operations Manual Operations  79
Configuring the Command Line Interface (CLI) session timeout:
The Set Option CLI Timeout command configures the CLI session timeout in minutes.
The valid timeout range is 1 to 1440 minutes (24 hours). The default session timeout is 5 minutes.
To configure the CLI Session Timeout:
At the Switched CDU: prompt, type set option clitimeout, followed by the session timeout (in minutes), and press
Enter.
Example:
The following command sets the CLI session timeout to 15 minutes:
Switched CDU: set option clitimeout 15<Enter>
Configuring the web session (Web Interface) timeout:
The Set Option Web Timeout command configures the Web session timeout in minutes.
The valid timeout range is 1 to 1440 minutes (24 hours). The default session timeout is 5 minutes.
To configure the web session timeout:
At the Switched CDU: prompt, type set option webtimeout, followed by the session timeout (in minutes), and press
Enter.
Example:
The following command sets the web session (Web Interface) timeout to 10 minutes:
Switched CDU: set option webtimeout 10<Enter>
Customizing the CLI prompt:
The Set Option Prompt command customizes the CLI prompt.
To customize the CLI prompt:
At the Switched CDU: prompt, type set option prompt and press Enter. Then type the custom prompt and press
Enter.
To reset the custom prompt to the default prompt, type set option prompt and press Enter. When prompted, leave
blank and press Enter.
The maximum length of the custom prompt is 31 characters. Spaces and special characters are allowed.
Example:
The following command sets the default CLI prompt to “My Prompt”:
Switched CDU: set option prompt<Enter>
Custom prompt <blank for default>: My Prompt:
Command successful
My Prompt:
Enabling or disabling StartUp Stick:
The Set Option Startupstick command enables or disables the StartUp Stick tool for PDU mass configuration of
operating parameters.
To enable or disable StartUp Stick:
At the Switched CDU: prompt, type set option startupstick, followed by enabled or disabled and press Enter.