Various cycles and functions
21
Various functions
Delay end
Press DELAY END button to set the program end
(Delay end) time in one hour increments to a
maximum of 24 h (hours). After selecting the desired
washing program but before pressing the
START/PAUSE button, press the DELAY END
button until the desired time is displayed, e.g. 8h,
with the DELAY END indicator light lit.
NOTICE: The cycle duration is included in the set
Delay End time.
Here is an example of a 1hr: 30 min cycle time and an
8 h Delay end time.
8 h is displayed and count down (approximately 6 h:
30 min) until the washing cycle begins (at 1hr: 30 min)
then the cycle duration 1: 30 is displayed and began.
Total time approximately is 8 hours.
The way to cancel Delay End function:
Turn the wash cycle selector knob to reset the
wash cycle. The DELAY END indicator light
goes out.
NOTICE:
Delay End function cannot be set in some wash
cycle.
The actual end time of the wash cycle may be
different from the set Delay End time depending
on the water supply pressure, drainage, clothing
type, water temperature and other conditions.
Child lock
1. Setting the Child lock function can avoid children's
miss-operation and external interference to the
washing procedure.
2. During operation, long press the SPEED button for
3 seconds to set or cancel the Child lock function.
3. After the Child lock function is set, the Child lock
indicator light is lit, the door cannot be opened,
the control panel is locked, all buttons on control
panel do not respond, and wash cycle selector knob
on control panel (except the Linear mark on the wash
cycle selector knob under the symbol “ “) do not
respond too. You can only turn off the machine by
turn the wash cycle selector knob, when the Linear
mark on the wash cycle selector knob under the
symbol “ “, the machine will be turned off and
stop running. If the machine is turn off, the Child lock
function will been cancelled.
4. After the Child lock function is set, you can turn off
the machine by turning the wash cycle selector knob.
When the machine is turned on again, the machine
directly run the program before turning off the
machine.
Add clothes during the program is
running
When the program is running, long press the
START/PAUSE button to pause the machine, if
the DOOR LOCK indicator light goes out, the
door may be opened, you can add or take out laundry.
After the operation is completed, close the door, long
press the START/PAUSE button again, and the
machine continues to run from the point at which it
was interrupted,.
NOTICE:
If the water level or water temperature in the drum
is too high, the door lock indicator light is lit, the
door cannot be opened and cannot add or take out
clothes during the program is running.
To Next Page
Loading...
