Safety instructions
4
1 The appliance must not be installed behind a
lockable door, a sliding door or a door with a hinge
on the opposite side to that of the appliance, in
such way that a full opening of the appliance door is
restricted.
1 The appliance must be disconnected from the
power supply before any installation operation –
risk of electric shock.
1 Installation, including water supply (if any) and
electrical connections and repairs must be carried
out by a qualified technician.
1 Connect the water inlet hose(s) to the water supply
in accordance with the regulations of your local
water company.
1 Use only the new water inlet hose(s) supplied with
the appliance to connect the appliance to water
supply. The old water inlet hose(s) should not be
reused.
1 The supply water pressure must be in the 0.03—1.0
MPa range.
1 Make sure that the ventilation openings in the base
of the appliance (if available on your model) are not
obstructed by a carpet or other material.
1 After installation of the appliance, wait a few hours
before starting it so that it acclimates to the
environmental conditions of the room.
1 Once installed, packaging waste (plastic, Styrofoam
parts etc.) must be stored out of reach of
children – risk of suffocation.
1 Only activate the appliance when the installation
has been completed.
ELECTRICAL WARNING
1 It must be possible to disconnect the appliance
from the power supply by unplugging it if plug is
accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety standards.
1When the appliance is installed, the mains
socket must be within easy reach.
1 When heating, the maximum current of the
appliance is 10A, so please make sure that the power
supply system (voltage, current and the cable) is
applicable to the load of the applied appliance.
1 In order to ensure your safety, you must plug the
cable into a socket which connected to earth. And
please check your socket to make sure that it is
connected with reliable earth correctly.
1 Do not use extension leads, multiple sockets or
adapters.
1The electrical components must not be accessible
to the user after installation.
1Do not operate the appliance when you are wet or
barefoot.
1Do not operate the appliance if it has a damaged
power cable or plug, if it is not working properly, or if
it has been damaged or dropped.
1 If the supply cord is damaged, it must be replaced
with an identical one by the manufacturer, its service
agent or similarly qualified persons in order to avoid
a hazard – risk of electric shock.
1Disconnect the power cord by grasping the plug,
not the cord.
CLEANING AND MAINTENANCE
1 WARNING! Ensure that the appliance is switched
off and disconnected from the power supply and turn
off the water tap before performing any
maintenance operation; never use steam cleaning
equipment – risk of electric shock.
1 Use caution when draining hot water from the
drum such as during pump maintenance.
To Next Page
Loading...
