23
T UNITS
T units are tamperproof user-definable units which are indirectly changed by enter-
ing a factor or divisor. To change T units, proceed as follows:
1. Calculate the ratio you wish to enter. If your ratio is in grams per T unit, ounces
per T unit, etc., you will enter a divisor. Proceed with Steps 2 through 10.
If your ratio is in T units per gram, T units per ounce, T units per pound, etc., you
will enter a factor. Proceed with Steps 2 through 10 skipping step 6.
2. Press the conv key until the display reads in the units from which you wish to
convert.
3. Press the — key.
4. Enter 1732. This is the tamperproof code.
5. Press the setup/cal key.
6. If you are entering a divisor, press —.
7. Enter the conversion ratio.
8. Press the setup/cal key.
9. Place an object to be weighed on the scale.
10. Wait for the "ok" symbol, then read the display. The weight is given in T units.
To Next Page
Loading...
