EasyManuals Logo

Setra Systems 5000C User Manual

Default Icon
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
RESTORING THE FACTORY DEFAULT SETUPS
The many features described in this section allow the user to customize the scale to
suit a particular application. However, in doing this it is also possible to inadvertently
setup the scale in such a way that it will not operate as expected. To reset the scale
to the original factory defaults, follow the steps outlined below.
The factory defaults are set as follows:
- Baud rate is equal to 2400 and no parity.
- print is assigned to the standard serial tape printer (Setra 240P) with all avail-
able data being printed.
- ./rcl , print is assigned to the Setra Auto Count 200 bar code label printer (version
2.05 and lower.)
- No minimum sample size.
- No minimum accuracy.
- The beeper is enabled.
- The INT mode is set to fast display update (short integration time).
- Span = factory calibration.
- Dual scale mode is disabled.
- X units = 1 gram.
- T units = 1 grain.
To restore the factory default setups use the following procedure:
1. Press the key and enter 8888 .
2. Press the setup/cal key. The display will read “d-noS”.
3. Press the setup/cal key to restore the factory defaults. Press clear if you do not
wish to proceed.
4. The scale will reset itself.
DISABLING TONE
Your Setra scale emits a tone when a number or function is entered. To disable the
tone, use the following procedure:
1. Press the key and enter 9999 .
2. Press the setup/cal key. The tone is disabled.
Note: To enable the tone, repeat these two steps.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Setra Systems 5000C and is the answer not in the manual?

Setra Systems 5000C Specifications

General IconGeneral
BrandSetra Systems
Model5000C
CategoryScales
LanguageEnglish

Related product manuals